By Will Rietveld
Gossamer Gorilla pack on a 6-day mostly off-trail
backpacking trip in the Weminuche Wilderness in southwest Colorado.
I was very impressed with the original Gorilla pack when I
reviewed it for Backpacking Light Magazine in 2009, and it earned a Highly
Recommended rating. Very few pieces of gear merit the coveted Highly
Recommended rating. So how does the updated 2012 Gorilla compare with the
original, and does it still deserve an outstanding rating?
At 3000 cubic inches (49 L), the Gorilla is sized for the
lightweight backpacker who carries loads in the 20-30 pound range, or an
ultralight backpacker for a longer trip without resupply. The Gorilla is the
answer to the question: “If I were to buy just one backpack, which one should I
get?” Its volume and features allow this one pack to be used for both
ultralight and lightweight backpacking.
However, if you are consistently an ultralight backpacker,
with a base weight under 10 pounds and total pack weight under 20 pounds, you
should be looking at Gossamer Gear’s Murmur or Kumo packs for the appropriate
volume needed and lower pack weight.
Description
Gossamer Gear now uses its proprietary 140 denier Dyneema
Gridstop fabric throughout its backpack line. This fabric is ideal for a
lightweight backpack because it’s the perfect balance of light weight,
durability, and longevity. Some other pack fabrics are lighter – like silnylon
and Cuben Fiber – but they don’t have a lot of durability and longevity, and
Cuben Fiber is expensive. Actually the proprietary 140 denier Dyneema Gridstop
is expensive too, almost as much as Cuben Fiber, but Gossamer Gear uses it
because it’s the ideal pack fabric.
The following photo gallery shows the design and features of
the 2012 Gorilla pack.
Frontpanel View. The updated 2012
Gossamer Gear Gorilla pack has 3000 cubic inches of volume, weighs 25 ounces
(size Medium), and costs $225. The pack comes complete with removable hipbelt
(4 sizes available) with two attached pockets, a bungie compression system,
removable contoured stay, backpanel pad, and removable sternum strap. The large
stretch nylon front pocket expands to hold a lot of gear.
Backpanel
View. The backpanel has Gossamer Gear’s traditional sleeping pad sleeve
which will hold a closed cell foam pad or slightly aired inflatable pad. A
SitLight pad is included (not shown), which can be easily removed to use as a
sit pad on breaks. The hipbelt is about 1 inch wider than the previous Gorilla
and now has attached pockets which are very roomy and open across the top and
part way down the buckle side for easy access. The shoulder straps are a
fully-padded and 3.75 inches wide. Another nice feature is the new
EZClip™ sternum strap attachment, which makes the height adjustment very
easy.
Top Cover.
The Gorilla is a top loader. The old drawcord and top strap design is replaced
by a new OTT™ (Over-The-Top) closure system that is held down with two
lightweight drawcord buckles. The top flap sheds rain and also has an
integrated zippered top pocket.
Removable
stay. A U-shaped contoured tubular aluminum stay slides into sleeves
on the inside of the pack’s backpanel. The final production pack has a 1.5-inch
wide Velcro hold-down patch at the center of the stay. The stay can be bent to
match the curvature of the user’s back.
Testing Results
I tested the Gorilla on two backpacking trips and four day
hikes with loads ranging from 16 to 31 pounds. From a previous load testing
project, I found that a removable stay is beneficial for loads greater than 15
pounds, so I left the stay in during all of my testing of the Gorilla.
As expected, I found the Gorilla very comfortable to carry
with loads in the 16 to 22 pound range. Above that, the pack has increasing
torso collapse, so it does not completely transfer weight to the hips. At 31
pounds (the heaviest load I tested), I estimate that 25% of the weight was on
my shoulders. This is not unusual since a removable stay is merely a pack
stiffener and not a structural frame. For
carrying heavier loads, the Gorilla’s wide hipbelt and especially wide shoulder
straps really help for distributing the weight.
One modification I made to the Gorilla is the
addition of lightweight drawcord compression straps in place of the pack’s
bungee compression system. While some hikers like an external bungee system for
attaching things (like a jacket) to the outside of a pack, I prefer
conventional compression straps, ideally three on each side. A bungee system
does not compress the pack as well for smaller loads, and can block access to
the front pocket. My preference is for three compression straps per side for
effective pack volume reduction, and offering a bungee system as an accessory.
Overall Impressions
On the plus side I really like the 140 denier Dyneema
Gridstop fabric, wider shoulder straps, Over the Top cover with zippered pocket,
wider hipbelt with pockets, contoured stay, easy sternum strap adjustment (or
removal), and easier hipbelt removal. These are some substantial improvements,
while adding only about 1 ounce of additional weight (by my measurement).
On the minus side I have one main issue: as discussed under the last photo, I personally prefer three webbing compression straps on each side of the pack for
more effective pack volume adjustment. A bungie attachment system can be a nice
accessory for attaching things to the outside of the pack, but I don’t particularly like a bungee system for pack compression. This is a issue of personal preference, and Gossamer Gear apparently likes bungee systems. Pack
owners who want compression straps can easily remove the bungee system and
replace it with three compression drawcords on each side (as shown
above), or by zig-zagging a single cord on each side and securing it with a
single cordlock at the top.
Finally, it is time to go a step further and design a removable stay system that transfers that better transfers weight to the hipbelt. In the present design the stay simply floats in sleeves attached to the backpanel and acts as a pack stiffener, not a frame. Since many lightweight backpackers nowadays use a lightweight inflatable pad instead of a closed cell foam pad, they don’t have the CCF pad to assist with weight transfer in the current pack design. The stay developed by Gossamer Gear is an excellent design, but it would transfer weight much better if it were more solidly anchored to the shoulder straps at the top and to the hipbelt at the bottom. Such a design can be kept lightweight, transfer weight more effectively, and retain the benefits of a removable stay.
Overall, the 2012 Gorilla is a superb pack for carrying
lightweight moderate volume loads in the 15 to 25 pound range, and occasionally
higher. It is truly a single lightweight backpack that can do it all,
eliminating the need to own multiple packs. The 2012 upgrade incorporates some
substantial improvements over the original, with only a minimal increase in
weight, which is remarkable. The issues discussed above also apply to the
original Gorilla, but overall the new Gorilla is better than ever and still
merits an outstanding rating.
